LOT OF ALL MOST 2000pc MIX SIZE WATCH HOLE JEWELS FOR PARTS & WATCHMAKERS M-9788

Description

Empire.of.vintage_watches
please click here for other auctions
please check the title as if title states it is not working then it is non working,as we do sell some watches as for watches for parts too so we do not want you to get confuse
We guarantee you that the watch is in perfect working order. It has been recently serviced by our experts and will be checked for almost 72 hours before packing it for you.
Since it’s a refurbished watch, it may give a time difference of few minutes (+/-) in 24 hours.
Although the watch is in perfect working condition, we still request you to check the photographs thoroughly for any defects/age marks in the watch.
Please note that these watches are vintage and used. We have refurbished these watches by keeping the original mechanism. However, we do change some parts like strap, dial that may have worn out or we do some polishing, buffing and re-servicing as and where required.
*STRAP ATTACHED WITH THE WATCH IS FREE OF COST*
ü
We do take bulk/wholesale orders of watches and straps, contact us for prices.
ü
Any defects not mentioned in the description but can be seen in the pictures will be considered as described.
ü
We don't take guarantee of any watch of its Waterproof as these are vintage watches and have been used for years.
ü
No Box & Papers will come with the watch and if so we will describe it.
MBA Swiss Bracelet Tool This is a new issue from Bergeon and is very nice. While standard bracelet tools help remove pins, sometimes lining up the pin with the pusher is a challenge. Not with this tool! The bracelet is securely held in place against the rotating platform by a nylon-tipped spindle that is smoothly operated by the handle. The working surfaces of the rotating platform are covered with pads of hard rubber to avoid scratches. There is a slot in the platform to allow the pins to pass through. The double-articulating head can easily be positioned anywhere over the bracelet. The tool is mounted on a base that has rubber feet; it also has a hole so it can be screwed down. The pusher holder has a knurled head and a shaft that is 4.7 mm in diameter (the same as the 6745 and 6744 bracelet tools). Six different pin pushers (0.40 - 2.00 mm) are included with a wooden base. A replacement nylon head for the locking spindle is also included. The tool weighs almost 1-3/4 lbs (6x heavier than the 6745). The articulating head in particular is extremely well made- smooth as silk with no extra play. Note that it is not designed to remove screws but I'm sure a handy person could adapt it. This tool will turn one of the most common procedures in watch repair into a pleasure. Swiss made.
Click here to see my other auctions